1. This forum is in read-only mode.

Dual-booting

Discussion in 'Non-Emulation Help' started by Nemephosis, Sep 25, 2009.

  1. Nemephosis

    Nemephosis Active Member

    Hello, fine folks! I've been around the forums for a while now, and I have a question.

    I use an Acekard 2i with the AKAIO 1.5 firmware. Is it possible to have both the AKAIO and Moonshell on it at the same time? And let's say it boots into the AKAIO firmware, can Moonshell be run from within that to make it reset and boot into MS firmware? I want to try it out but I can't be bothered switching out all the firmware all the time, nor do I see a point getting a second microSD card if I don't have to.

    Thanks guys.
     
    Nemephosis, Sep 25, 2009
    #1
  2. kamuikurou

    kamuikurou Well-Known Member

    I think Moonshell is not a firmware, but it runs on a flashcart firmware. I guess you should try putting everything into your AKAIO SDcard and treat moonshell just like any other roms. :D
     
    kamuikurou, Sep 25, 2009
    #2
  3. Nemephosis

    Nemephosis Active Member

    Well I am totally unfamiliar with how Moonshell works (I only know what it is) so I must admit, I'm not exactly sure what you just said... :p

    Like, do you start Moonshell just like you would any other game? Cause THAT, I understand. :p
     
    Nemephosis, Sep 25, 2009
    #3
  4. Loonylion

    Loonylion Administrator Staff Member

    you start moonshell like any other rom.
     
    Loonylion, Sep 25, 2009
    #4
  5. anandjones

    anandjones Well-Known Member

    MoonShell is a homebrew, not firmware/loader (although EZFlash V and Supercard DSONE firmware uses parts of its code).
     
    anandjones, Sep 25, 2009
    #5
  6. Nemephosis

    Nemephosis Active Member

    If you just start it like any other game, I'll figure it out from there. Thanks very much!
     
    Nemephosis, Sep 25, 2009
    #6