can't make my tales of eternia cd3 to work on my psx

the .isos I downloaded work in emulators, but when I use daemon tools to turn it in a cd, it stops working (at least on my friend's ePSXe), I tried using alcohol and a different emulator(emurayden) and it worked, but when I copied the cd with nero and put it in my psx, got stuck in the playstation screen, and made the same noise as the cds burned through daemon tools.
I already played cd1 and 2 without any problems, using daemon tools on the image and 48x, I really don't know what the problem is since the .iso works, never saw a something like that before so if anyone got an ideia, plz help me.

 

I burned twice, with 2x and 16x in this ImgBurn you said , the game worked , but the screen keeps moving, up and down (dunno how to explain that)
I copied the log here, the W is the triangle with an "!" and the I is the baloon with an !.

I 11:33:50 Verifying Session 1 of 1... (2 Tracks, LBA: 0 - 272100)
I 11:33:50 Verifying Track 1 of 2... (MODE2/FORM1/2352, LBA: 0 - 258442)
W 11:43:50 Miscompare at LBA: 258142, Offset: 2072, File: \SLUS_013.68
W 11:43:50 Device: 0x6D
W 11:43:50 Image File: 0xEC
W 11:43:50 Total Errors in Sector: 42
W 11:43:50 Note: The drive probably corrected the EDC Area because it's wrong in the image file.
I 11:43:50 Verifying Sectors...
W 11:43:53 Miscompare at LBA: 258163, Offset: 2072, File: \SLUS_013.68
W 11:43:53 Device: 0xFF
W 11:43:53 Image File: 0xA2
W 11:43:53 Total Errors in Sector: 72
W 11:43:53 Note: The drive probably corrected the EDC Area because it's wrong in the image file.
I 11:43:53 Verifying Sectors...
I 11:43:54 Verifying Track 2 of 2... (AUDIO/2352, LBA: 258443 - 272100)
I 11:44:15 Exporting Graph Data...
I 11:44:15 Export Successfully Completed!
I 11:44:15 Operation Successfully Completed! - Duration: 00:10:32
I 11:44:15 Average Verify Rate: 1.001 KB/s (6.7x) - Maximum Verify Rate: 2.445 KB/s (16.3x)

 

After reading the burn log, loony's advice may have gone un-noticed.

Just go burn speed 1x-1x.

The slower the better-16x is too much and makes a mess.

 

I was wondering why in the burn log appeared as 16x since this log is from when I tried putting the rate as 2x.
I 11:44:15 Average Verify Rate: 1.001 KB/s (6.7x) - Maximum Verify Rate: 2.445 KB/s (16.3x)

then I realized my mistake as I saw the disc information in ImgBurn.

Disc Information:
Supported Write Speeds: 16x; 24x; 40x; 48x

now I just need to check which cds got 1x supported, if you know a good one...
thanks a lot

 

That may be the cd drive fault-unless the cd say's iy.

WHat brand are you using-tdk and sony have done me well-but ritek is good I hear.